Custom Zebra Blinds Downtown Burlington – Free Installation

Wind off the lake gets into a unit fast once the door slides back, and a light blind will lift and tap the frame. A heavier bottom rail settles most of it. On the windows nearest the balcony we can also add side channels that hold the fabric plane in place. Tell us which openings you actually leave open and we will spec those differently.

Almost always the fabric was rolled unevenly at some point, or the brackets are not level with each other. Both are fixable in a service visit and neither means a new blind. A tube out of level by a couple of millimetres over two metres shows up as a slow drift after a few weeks of use. We shim the bracket and re-roll the fabric.

Yes, with the mount planned around the sash. An inside mount fouls the window when it tilts, so we go outside on the wall or the ceiling and run the blind past the frame on both sides. The blind then has to be raised before the window swings in. Units with tilt-and-turn glass are common enough here that we plan for it.

Water sitting against the fabric will mark it, and the sheer bands show it first. The blind is rarely the cause. Condensation on a condo window comes from indoor humidity meeting cold glass, and running the unit ventilation helps more than raising the blind does. Where a window regularly runs wet we set the bottom rail to clear the sill so nothing sits in a puddle.