Custom Motorized Blinds Uptown Waterloo – Free Installation

No. The limits and the pairing live in the motor and survive a flat battery, so a tube that has been charged goes back on the brackets and answers the same handset it did before. What can drift after a few hundred cycles is the bottom limit, by a millimetre or two, which shows as a thin line of light where there was none. Resetting it takes about a minute on the remote.

No, as long as water stays off the ends of the tube. Vacuum the fabric on low with the blind down, and wipe marks with a barely damp cloth. The motor is sealed inside the tube and the only opening that matters is the charge port, which sits at one end behind a small cover. Keep that dry, keep the bracket screws snug, and there is nothing else to service.

There is a button on the motor head itself that raises and lowers the blind, so you are never locked out. Remotes pair to the motor rather than the other way round, which means a replacement handset can be programmed to your existing blinds in a couple of minutes. If you have a hub, the app keeps working independently of the remote as well.

Roughly once a year in normal use, and sooner in a room that runs cold, since batteries lose capacity sitting against a big glass wall in January. Charging is a USB cable into a port at the end of the tube and takes a few hours. If a blind is somewhere awkward to reach, we can run the motor from a low voltage supply instead and take charging off your list.